sw806v2
 

The Lynx Audio™ SW-806V2 is an 8" active subwoofer set inside a custom ported transparent sound box with a built-in 500W Amplifier. The system is designed specifically for upgrading bass and two of the speaker components on either your factory stereo or aftermarket stereo. The sound box also has a hot flame lighting effect which can be set to illuminate continuously when the system in on or flash in sequence with the music.

The system comes complete with a pre-wired power harness that makes the installation go very quickly and easily without having to worry about installing all of the separate wiring that is normally required for a subwoofer / amplifier installation. Speaker level inputs and RCA inputs allow convenient connection to just about any factory or aftermarket sound system.

A wired gain / frequency control remote will allow to you to have complete control of how much bass you want in your music, plus you can tweak the phase control, bass boost and low-pass / high-pass crossovers from the amplifier itself giving you the best quality sound in your vehicle.
 
 
Max Power:
500W
R.M.S.
MAIN CHANNEL (4Ω, 1%THD): 2 × 50W
SUBWOOFER CHANNEL (4Ω, 1%THD): 170W
Speaker Size:
8"
Frequency Response:
MAIN CHANNEL (L/R): 20Hz ~ 22KHz
SUBWOOFER CHANNEL: 20Hz ~ 130Hz
Short Circuit Protection:
Yes
Thermal Protection:
Yes
Overload Protection:
Yes
Wired Remote:
Gain, Frequency and Light Control
Phase Switch:
0° / 180°
Dimensions:
75.5cm × 33cm × 33.5cm
29.7" × 13" × 13.1"
Weight:
26.4 lbs
Power Source:
12 Volt (Allowed 10 ~ 15 Volts)
 
   
  • Custom transparent ported sound box to achieve the cleanest sound
  • Flame lighting effect (Can be set to illuminate continuously or flash in sequence with the music)
  • RCA and speaker level inputs for use with aftermarket and factory head units
  • Complete wiring harness provided
  • High-pass filter witch: Full pass/86Hz
  • Low-pass: 50Hz ~125Hz
  • Wired remote with gain, frequency and lighting controls
   
 
 
 
The SW-806V2 is designed to be mounted in the trunk / cargo space of the vehicle and the pre-wired harness makes it very easy to connect the power, ground and signal wires. The harness also has 2 sets of line-output wires for connecting and amplifying two of the component speaker sets in the car. The wired remote will give the driver full-control of the bass so that they can adjust it to their liking as they listen to difference genres of music. The remote will also give them control of the lighting effects for the sound box. .